12.1 Changing the ODBC settings and the settings of an ODBC file data source

This section describes the procedure for changing the ODBC file data source name, the database name, and the contents of an ODBC file data source.

After you specify the ODBC file data source name, database name, and the contents of the ODBC file data source during setup of JP1/AJS3 that connects to an external database, you might need to change them later. The following table shows the items that you can change after operation has started.

Table 12‒1: Items that can be changed after operation starts
No.	Category	Item that can be changed	Reason for change
1	Environment setting parameters (specified by using the `jajs_setup` command during setup)	ODBC file data source name	The location of an ODBC file data source needs to be changed because of, for example, reorganization of disk contents.
2		Database name	The database name needs to be changed.
3	Item specified in the ODBC file data source	Address and port number of the connection-destination server	The address of the connection-destination server is changed in the cloud service being used.
4		User name	The password needs to be changed periodically according to the security policies.
5		Password

Cautionary note: When you change settings for the ODBC file data source, make sure that the correspondence between the scheduler services and databases does not change.

Organization of this section

To Page Top