Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Administration Guide


6.3.2 Issuing a JP1 event when a JP1/AJS3 process starts, stops, or terminates abnormally

If a process starts, stops, or terminates abnormally, JP1/AJS3 outputs an error message to the integrated trace log.

In JP1/AJS3 - Manager and JP1/AJS3 - Agent, the message can also be issued as a JP1 event. For details about the JP1 events to be issued, see A. JP1 Events Issued by JP1/AJS3.

You can specify settings to issue a JP1 event in the following cases:

#:

A JP1 event is issued if automatic restart of processes has been set.

The settings for issuing a JP1 event are specified in the jp1ajs_param.conf file. By default, JP1 events are not issued.

To enable issuance of JP1 events:

  1. Edit the jp1ajs_param.conf file.

    The location of the jp1ajs_param.conf file is as follows:

    • Windows: JP1/AJS3-installation-folder\conf\jp1ajs_param.conf

    • UNIX: /etc/opt/jp1ajs2/conf/jp1ajs_param.conf

    For details about how to define the jp1ajs_param.conf file, see 6.3.3 Format of the jp1ajs_param.conf file.

    If you do not have the jp1ajs_param.conf file, copy jp1ajs_param.conf.model from the above directory.

  2. Execute the jbssetcnf command.

    jbssetcnf jp1ajs_param.conf

    For details about the jbssetcnf command, see the description of this command in the JP1/Base User's Guide.

  3. Restart JP1/AJS3.

    The settings in the jp1ajs_param.conf file are applied.

You can also use the jajs_config command to define whether to issue a JP1 event as a separate specification. For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference. For details about the environment setting parameters that define whether to issue a JP1 event, see 20.3 Setting up the system management environment in the JP1/Automatic Job Management System 3 Configuration Guide.