6.2 Changing the behavior at JP1/AJS3 startup or termination

By specifying a parameter option for the JP1/AJS3 service, you can temporarily change the behavior of JP1/AJS3 when it starts.

By executing the jajs_spmd_stop command with a parameter option specified, you can temporarily change the behavior of JP1/AJS3 when it terminates.

The following describes the options you can specify for services and commands, and how to change the behavior.

Organization of this section

• 6.2.1 Temporarily changing the start mode of JP1/AJS3

• 6.2.2 Temporarily changing the end mode of JP1/AJS3

To Page Top