Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


D.4 Setting the AJS administrator

To set the AJS administrator:

  1. Specify the OS user you created for the AJS administrator for the JP1AJS3_ADMINUSR_NAME environment variable.

  2. Install JP1/AJS3.

    For details about the installation procedure, see 12.2 Installing JP1/AJS3 series programs.

  3. Execute the jajsshowadminusr command and confirm that the AJS administrator was set correctly.

    For example, execute the jajsshowadminusr command as follows:

    # /opt/jp1ajs2/bin/jajsshowadminusr

    For details about the jajsshowadminusr command, see jajsshowadminusr (UNIX only) in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.

  4. If you use the system in a cluster configuration or use a disaster recovery operation, make sure that the following values are the same for the primary node and the secondary node, and for the main site and the remote site:

    • Name of the OS user group for the JP1 administrators group

    • Group ID of the OS user group for the JP1 administrators group

    • Name of the OS user for the AJS administrator

    • User ID of the OS user for the AJS administrator