24.2 Setting up JP1/AJS3 to use an external database
This section describes how to set up JP1/AJS3 to use an external database.
Note that you cannot use an external database on a host on which both the embedded database environment and external database environment exist. Therefore, when you perform a new installation of JP1/AJS3, make sure that an embedded database is not automatically set up during installation. If an embedded database is set up during installation, before you set up the external database environment, you must delete the embedded database environment that was set up.
For details about the conditions for using an external database and about the basic configuration, see 2.11 Considering use of an external database in a cloud environment in the JP1/Automatic Job Management System 3 System Design (Configuration) Guide.
For details about how to export the data of JP1/AJS3 that was previously managed by using the embedded database to an external database, see 24.3.1 Procedure for exporting data to the external database.
- Organization of this section