15.9.2 Changing the JP1/AJS3 database configuration to the standard configuration without ISAM
This subsection describes how to change the JP1/AJS3 database configuration from the standard configuration to the standard configuration without ISAM. In JP1/AJS3 - Manager installed as a new installation, the database configuration is the standard configuration, not the standard configuration without ISAM.
To change the database configuration to the standard configuration without ISAM, edit the jp1ajs_hstd.conf file in the service configuration file storage directory.
-
If you updated the jp1ajs_hstd.conf file during configuration of the scheduler status monitoring
Back up the jp1ajs_hstd.conf file, and then delete the following line from the jp1ajs_hstd.conf file:
jpqman_hst|/opt/jp1ajs2/bin/jpqman|||1800|
-
For any other cases:
Back up the jp1ajs_hstd.conf file, and then delete it. Next, copy the jp1ajs_hstd.conf.isamless.model file, and then rename the copy to jp1ajs_hstd.conf.
To return the database configuration to the standard configuration, overwrite the jp1ajs_hstd.conf file with a copy of the backup file.
In a physical host environment, the service configuration file storage directory is /etc/opt/jp1ajs2/conf/. In a logical host environment, the service configuration file storage directory is shared-disk-directory-specified-by-the-jajs_setup_cluster-command/jp1ajs2/conf.
- Cautionary note:
-
If you change the database configuration to the standard configuration without ISAM, some functions are no longer available. For details, see 1.4 JP1/AJS3 database configurations in the manual JP1/Automatic Job Management System 3 Overview.