15.7.1 Settings for the performance report output function

In JP1/AJS3, you can output performance reports that detail the processing amounts and job execution statuses for each scheduler service, to gain an accurate understanding of the operating status of JP1/AJS3. The following procedure describes how to enable the performance report output function.

Organization of this subsection

(1) Definition procedure
(2) Environment setting parameter

(1) Definition procedure

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
Execute the following command to set the environment setting parameter described in (2) below:
```
jajs_config -k "definition-key" "parameter-name"=value
```
Restart JP1/AJS3.

The new settings are applied.

To Page Top

(2) Environment setting parameter

Table 15‒70: Environment setting parameters for setting up the performance report output function
Definition key	Environment setting parameter	Explanation
`[{JP1_DEFAULT\|logical-host}\JP1AJSMANAGER\scheduler-service]`^#	`"AJSREPORTUSE"=`	Enables or disables the performance report output function.
	`"AJSREPORTDIR"=`	Specifies the directory to which performance log files are to be output.
	`"AJSREPORTSTOREDAYPERIOD"=`	Specifies the minimum retention period (in days) for performance log files.

#:: The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of these environment setting parameters, see the following:

To Page Top