15.6.1 Settings for outputting error messages for jobs to syslog
You can output error messages for jobs (KAVS, KAVT, and KAVU messages) to syslog so that you are able to use only syslog to monitor errors occurring during job execution in JP1/AJS3.
The following describes the procedure for specifying the settings for outputting error messages for jobs to syslog.
- Organization of this subsection
(1) Definition procedure
-
Stop the JP1/AJS3 service.
Execute the following commands to confirm that all processes have stopped:
# /etc/opt/jp1ajs2/jajs_stop#1 # /opt/jp1ajs2/bin/jajs_spmd_status
- #1:
-
Confirm that automatic termination has been set.
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k "definition-key" "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied.
(2) Environment setting parameter
|
Definition key |
Environment setting parameter |
Explanation |
|---|---|---|
|
[{JP1_DEFAULT|logical-host}\JP1AJS2COMMON]# |
"SYSLOGJOBMSG"= |
Specifies whether to output error messages for jobs to syslog. |
- #:
-
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 20.11.2(2) SYSLOGJOBMSG.