15.3.18 Settings for monitoring a network file by using a file monitoring job

(1) Definition procedure

1. Stop the JP1/AJS3 service.

   Execute the following commands to confirm that all processes have stopped:

   # /etc/opt/jp1ajs2/jajs_stop#1
   # /opt/jp1ajs2/bin/jajs_spmd_status

   #1:

   Confirm that automatic termination has been set.

2. Execute the following command to set the environment setting parameter described in (2) below:

   jajs_config -k "definition-key" "parameter-name-1"=value-1 ["parameter-name-2"=value-2]

3. Restart JP1/AJS3.

   The new settings are applied.

To Page Top

(2) Environment setting parameter

Table 15‒65: Environment setting parameters for monitoring a network file by using a file monitoring job

Definition key	Environment setting parameter	Explanation
[{JP1_DEFAULT|logical-host}\JP1AOMAGENT]#	"NetworkFilewatch"=	Sets whether to monitor a file by using a file monitoring job via a network.
	"NetworkFilewatchTimeout"=	Sets the timeout period before a file monitoring job cancels monitoring of a file via a network.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of these environment setting parameters, see the following:

• 20.6.2(30) NetworkFilewatch

• 20.6.2(31) NetworkFilewatchTimeout

To Page Top