Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


15.3.8 Applying a timeout for receiving data in inter-process communication by event/action control

If event/action control cannot perform inter-process communication normally due to heavy network load or a line error, the following problems could occur:

You can prevent these problems from occurring by enabling the option that applies a timeout for receiving data in inter-process communication by event/action control.

The following describes how to enable this option.

Organization of this subsection

(1) Definition procedure

  1. Stop the JP1/AJS3 service.

    Execute the following commands to confirm that all processes have stopped:

    # /etc/opt/jp1ajs2/jajs_stop#1
    # /opt/jp1ajs2/bin/jajs_spmd_status
    #1:

    Confirm that automatic termination has been set.

  2. Execute the following command to set the environment setting parameter described in (2) below:

    jajs_config -k "definition-key" "parameter-name"=value
  3. Restart JP1/AJS3.

    The new settings are applied.

(2) Environment setting parameter

Table 15‒54: Environment setting parameter used to apply a timeout for receiving data

Definition key

Environment setting parameter

Explanation

[JP1_DEFAULT\JP1AOMAGENT]#

"RecvTimeout"=

Specifies whether to apply the timeout for receiving data in event job socket communication.

#:

The specification of this parameter is effective on the physical host and all logical hosts.

For details about the definition of this environment setting parameter, see 20.6.2(34) RecvTimeout.