15.1.9 Settings for using the temporary change operation management function
When you display a list of information about operations such as Change Plan and Change Hold Attribute performed on jobnets, or re-execute a temporary change operation selected from the temporary change information list, you need to enable the temporary change operation management function.
The temporary change operation management function is disabled by default. To use this function, enable the SAVEPLANINFO environment setting parameter.
The following describes the procedure for using the temporary change operation management function.
- Organization of this subsection
(1) Definition procedure
-
Stop the JP1/AJS3 service.
Execute the following commands to confirm that all processes have stopped:
# /etc/opt/jp1ajs2/jajs_stop # /opt/jp1ajs2/bin/jajs_spmd_status
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k "definition-key" "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied to the configuration definition.
(2) Environment setting parameter
|
Definition key |
Environment setting parameter |
Explanation |
|---|---|---|
|
[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]# |
"SAVEPLANINFO"= |
Enables or disables the temporary change operation management function. |
- #:
-
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 20.4.2(102) SAVEPLANINFO.