15.1.2 Changing the level of messages output from scheduler services to the integrated trace log

(1) Definition procedure

1. Stop the JP1/AJS3 service.

   Execute the following commands to confirm that all processes have stopped:

   # /etc/opt/jp1ajs2/jajs_stop
   # /opt/jp1ajs2/bin/jajs_spmd_status

2. Execute the following command to set the environment setting parameter described in (2) below:

   jajs_config -k "definition-key" "parameter-name"=value

3. Restart JP1/AJS3.

   The new settings are applied to the configuration definition.

To Page Top

(2) Environment setting parameter

Table 15‒2: Environment setting parameter used to change the level of messages output from scheduler services to the integrated trace log

Definition key	Environment setting parameter	Explanation
[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]#	"HNTRLOGLEVEL"=	Specifies the level of messages to be output to the integrated trace log.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of this environment setting parameter, see 20.4.2(56) HNTRLOGLEVEL.

To Page Top