14.2.1 Procedure for setting the environment setting parameters by using the jajs_config command

To use the jajs_config command to change the settings in the common definition information:

1. Stop the JP1/AJS3 service.

   Execute the following commands to confirm that all processes have stopped:

   # /etc/opt/jp1ajs2/jajs_stop#1
   # /opt/jp1ajs2/bin/jajs_spmd_status

   #1:

   Confirm that automatic termination has been set.

2. Change the settings in the common definition information.

   Use the following command to specify new environment setting parameter settings in the common definition information:

   jajs_configΔ-kΔ"definition-key"Δ"parameter-name-1"=value-1Δ["parameter-name-2"=value-2] ...

   Legend:

   Δ: One-byte space

   Example:

   jajs_config -k "[JP1_DEFAULT\JP1AJSMANAGER\AJSROOT1]" "LOGSIZE"=dword:00002800 "AJSLOG"="all"

3. Restart JP1/AJS3.

   The changes in the common definition information are applied to JP1/AJS3.

Supplementary note:

You can specify only one definition key for definition-key. To set environment setting parameters that have different definition keys, run the jajs_config command for each definition key, or use the jbssetcnf command.

To Page Top