13.5.1 Settings for enhancing the embedded database management function

(1) Procedure for enhancing the embedded database management function

After performing an upgrade installation of JP1/AJS3 - Manager, perform the following procedure for all the hosts you set up.

To enhance the embedded database management function:

1. Execute the ajsembdbinstl command to perform an overwrite installation of the embedded database.

   For details about the ajsembdbinstl command, see ajsembdbinstl in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference.

2. Change the setting in the system common definition file for the embedded database.

   Use an editor such as vi to open the following file, and then change the settings.

   System common definition file:

   embedded-database-practical-directory/conf/pdsys

   Before the change:

   set pd_mode_conf = AUTO^#

   After the change:

   set pd_mode_conf = MANUAL2

   #

   In a logical host environment, the value before the change is MANUAL1.

   If AUTO or MANUAL1 is set in the system common definition file, change the value to MANUAL2.

3. Copy the model files to the JP1/AJS3 startup process definition file and JP1/AJS3 extended startup process definition file, which are used for database management.

   Overwrite the following files by copying the model files.

   File type	File name	Model file
   JP1/AJS3 startup process definition file (database management)	For a physical host: /etc/opt/jp1ajs2/conf/jp1ajs_dbmd.conf For a logical host: shared-directory/jp1ajs2/conf/jp1ajs_dbmd.conf	/etc/opt/jp1ajs2/conf/jp1ajs_dbmd.conf.model
   JP1/AJS3 extended startup process definition file (database management)	For a physical host: /etc/opt/jp1ajs2/conf/jp1ajs_dbmd_0700.conf For a logical host: shared-directory/jp1ajs2/conf/jp1ajs_dbmd_0700.conf	/etc/opt/jp1ajs2/conf/jp1ajs_dbmd_0700.conf.model

4. Change the setting in the JP1/AJS3 extended startup process definition file used for system management.

   Use an editor such as vi to open the following file, and then change the underlined value in the line under Before the change.

   JP1/AJS3 extended startup process definition file (system management)

   - For a physical host:

   /etc/opt/jp1ajs2/conf/jp1ajs_service_0700.conf

   - For a logical host:

   shared-directory/jp1ajs2/conf/jp1ajs_service_0700.conf

   Before the change

   jajs_dbmd|jajs_dbmd||0|3|3|21600|0|2||1|||||||

   After the change

   jajs_dbmd|jajs_dbmd||1|3|3|21600|0|2||1|||||||

To Page Top

(2) Procedure for specifying the required settings when the embedded database management function is not enhanced

If you do not enhance the embedded database management function for reasons such as difficulty in changing the created environment, you need to perform the following when you use the ajsembdbinstl command to install an embedded database or create or re-create a logical host.

To Page Top