13.2.2 Setting up JP1/AJS3 - Agent

This subsection describes how to set up JP1/AJS3 - Agent. Before you set up JP1/AJS3 - Agent, make sure that you have superuser permissions.

Make sure that JP1/Base has already been set up before you attempt to set up JP1/AJS3 - Agent.

Make sure that the umask for the user who starts JP1/AJS3 permits viewing and updating by any user who executes JP1/AJS3 commands.

Note that this subsection describes the basic setup of JP1/AJS3. If you need to change the settings to match specific operating requirements, see the appropriate section listed in the following table.

Topic	Reference
Procedure for setting environment setting parameters	14.2
Procedure for restricting connections to JP1/AJS3	21.2
Settings for defining the work path to be used during job execution as a variable	15.2.1
Changing the timeout value for pipe communication of the agent	15.2.15
Setting the timeout value for receiving notification from the job process that execution is ready	15.2.16
Changing the settings related to the size of the log for event jobs to match operational requirements	15.3.1
Setting the status passing option for the file monitoring job	15.3.3
Settings for automatic startup and termination of the JP1/AJS3 service	15.9.1
Settings for the JP1/AJS3 definition pre-check function	15.5.1
Settings for logging	16
Setting up for a cluster system	17

Organization of this subsection

(1) Setup procedure

(1) Setup procedure

To set up JP1/AJS3 - Agent:

If necessary, change the environment setting parameters.

Skip this step if you accept the environment setting parameter values proposed by JP1/AJS3. To change environment setting parameter values, use the jajs_config command, or the jbssetcnf command provided by JP1/Base.

For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference. For details on the jbssetcnf command, see the JP1/Base User's Guide.
Set up the system and user environments.

For details about setting up the system and user environments, see 13.4 Setting up the system and user environments.
If necessary, set the method for automatic startup and termination of the JP1/AJS3 service.

For details about setting the method for automatic startup and termination of the JP1/AJS3 service, see 15.9.1 Setting automatic startup and termination of the JP1/AJS3 service.

JP1/AJS3 - Agent setup is complete.

To Page Top