12.2.1 Points you must check before installation
This subsection describes the points that you must check before installing JP1/AJS3 series programs.
-
To install JP1/AJS3 on a physical host, set the host name by using 1 to 63 bytes. To install JP1/AJS3 on a logical host, set the host name by using 1 to 32 bytes.
-
JP1/AJS3 supports Japanese, English, Simplified Chinese, Korean, German, French, Spanish, and Russian. If JP1/AJS3 is to be used in a particular language (Japanese, English, Simplified Chinese, Korean, German, French, Spanish, or Russian), before installing JP1/AJS3, make sure that the language settings are the same on all of the hosts on which JP1/AJS3 is to be installed.
For details about how to specify the settings for using the desired language, see 2.4.2(11) About the operations in multiple language environments in the JP1/Automatic Job Management System 3 System Design (Configuration) Guide.
- Organization of this subsection
(1) For JP1/AJS3 - Manager and JP1/AJS3 - Agent
-
Do not install JP1/AJS3 - Manager as a super user with one of the following names:
-
ALL
-
HiRDB
-
MASTER
-
PUBLIC
-
AJS2
If you install JP1/AJS3 - Manager as a super user with one of the preceding names, a problem occurs. For example, the JP1/AJS3 service might fail to start or setup of the embedded database might fail. Note that the case of letters in the super user name is not distinguished. Therefore, any strings obtained by converting from uppercase the strings above into lowercase such as "all" cannot be used.
-
-
If you are performing a new installation of JP1/AJS3 - Manager, make sure that the port number 22220, which is to be used for communicating with the embedded database, is available before performing the installation. If port number 22220 is to be used for a purpose other than for JP1/AJS3 - Manager, make sure that port number 22220 is available during installation of JP1/AJS3 - Manager. After JP1/AJS3 is installed, perform setup of the embedded database again to change the port number. For details about how to re-perform setup of the embedded database, see 23.4.1(6) Setting up an embedded database again.
(2) For JP1/AJS3 - Web Console
-
In accordance with the format specified in the RFC2609 standards, use only the following types of characters for the host name of the host to be installed:
-
Alphabetic characters (A to Z, a to z)
-
Numbers (0 to 9)#1
-
Hyphen (-)#2
-
Period (.)#3
- #1
-
Do not use a number directly after the last period.
- #2
-
Do not use a hyphen for the first or last character of the host name.
- #3
-
Do not use a period for the first or last character of the host name.
-
-
When performing a new installation of JP1/AJS3 - Web Console, make sure port numbers 22254, 22255 and 23152 can be used as the ports for internal communication. To use the port numbers for a purpose other than for JP1/AJS3 - Web Console, use the port numbers during installation of JP1/AJS3 - Web Console, and then change the port numbers.