8.2.5 Changing the common definition information
Cluster operation requires that the common definition information for JP1/Base, JP1/AJS3, and JP1/IM be the same on each physical host. After setting up JP1/Base, JP1/AJS3, and JP1/IM on the primary node physical host, and then changing the common definition information#, execute the following command to ensure that the information matches on both physical hosts.
Note that this operation affects all JP1/Base, JP1/AJS3, and JP1/IM products.
- On the primary node:
jbsgetcnf -h logical-host-name > backup-file-name
- On the secondary node:
jbssetcnf backup-file-name
- #:
-
While JP1/AJS3 is being used, the common definition information for JP1/Base, JP1/AJS3, and JP1/IM is updated at the following times:
-
When the common definition information is changed by using the JP1/Base jbssetcnf command. (This command adds the information in the environment settings files to the registry.)
-
When the JP1/AJS3 settings are changed by using either of the following JP1/AJS3 commands:
- jpqregguestuser
- jpqreguser
-
When JP1/AJS3 is set up by using any of the following JP1/AJS3 commands:
- jajs_setup
- jajs_config
- jajs_setup_cluster
- ajsembdbsetup
-
When settings in the Manager Environment Settings dialog box or in the Agent Environment Settings dialog box of JP1/AJS2 are changed
-
When linkage with JP1/AJS3 is set by using the JP1/Power Monitor jaomajs2confset command. (This command sets up the environment for controlling the host power in collaboration with JP1/AJS3.)
-