Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


6.8.3 Settings for permitting changing JP1 user passwords in JP1/AJS3 - View

To be able to change the password of a logged-in JP1 user in the connected JP1/AJS3 - View, enable the change password functionality for JP1 users in that JP1/AJS3 - View.

When this functionality is enabled, you can change the password of a JP1 user by selecting Options and then Change Password in the connected JP1/AJS3 - View.

Organization of this subsection

(1) Definition procedure

  1. In Windows Control Panel, open the Services administrative tool, and stop the following service:

    • JP1/AJS3 service

  2. Execute the following command to set the environment setting parameter described in (2) below:

    jajs_config -k definition-key "parameter-name-1"=value-1 ["parameter-name-2"=value-2]
  3. Restart JP1/AJS3.

    The new settings are applied.

(2) Environment setting parameters

Table 6‒77: The environment setting parameter for permitting changing JP1 user passwords in JP1/AJS3 - View

Definition key

Environment setting parameter

Explanation

[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER]#

"CHANGEPASSWORD"=

Sets whether the change password functionality for JP1 users is to be used in JP1/AJS3 - View.

"CHANGEPWDLOG"=

Sets whether messages related to changing of the JP1 user password are to be output in JP1/AJS3 - View.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of these environment setting parameters, see the following:

(3) Notes