Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


6.3.13 Setting the connection timeout for communication between the event/action control manager and agent

When an event job or a jobnet with start conditions is executed, the event/action control manager and the event/action control agent communicate with each other. Because the timeout for connection between the manager and the agent depends on the OS, a wait of 20 to 30 seconds is possible in the following cases:

If the above cases occur frequently, the process freezes intermittently because there is a long wait for each connection. As a result, an event job or a jobnet with start conditions executed on another agent the manager can communicate with might be delayed for a long time or detection of an event might take an extremely long time. In such cases, adjust the connection timeout value by using the environment setting parameter described in (2) Environment setting parameter.

Use the procedure below for setting the environment setting parameter.

Organization of this subsection

(1) Definition procedure

  1. In Windows Control Panel, open the Services administrative tool, and stop the following service:

    • JP1/AJS3 service

  2. Execute the following command to set the environment setting parameter described in (2) below:

    jajs_config -k definition-key "parameter-name"=value
  3. Restart JP1/AJS3.

    The new settings are applied.

(2) Environment setting parameter

Table 6‒62: Environment setting parameter for the connection timeout between the event/action control manager and agent

Definition key

Environment setting parameter

Explanation

Event action control manager
  • For all scheduler services

    [{JP1_DEFAULT|logical-host}\JP1AJS2\HOST\NETWORK\EVMANAGER]#

  • For a specific scheduler service

    [{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service\NETWORK\EVMANAGER]#

Event action control agent

[{JP1_DEFAULT|logical-host}\JP1AOMAGENT]#

"ClientConnectTimeout"=

Connection timeout between the event/action control manager and agent

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about defining the environment setting parameters for the event/action control manager, see the following:

For details about defining the environment setting parameters for the event/action control agent, see the following: