Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


6.3.10 Setting the binding method applied to the outgoing communication used in the execution of event jobs

By default, the ANY binding method is set as the binding method applied to the communication used in the execution of event jobs to match the JP1/Base communication settings. In a cluster configuration, the IP binding method is automatically set for both physical and logical hosts when the cluster system is set up. The IP binding method is also set for both outgoing communication and incoming communication.

If multi-LAN connection is used, separate binding methods can be set in the JP1/Base communication settings for outgoing communication and incoming communication.

However, you can explicitly ensure that the binding method applied to incoming communication is always applied to the outgoing communication used in the execution of event jobs, regardless of the JP1/Base communication settings, by using the procedure described below.

Note, however, that if you install JP1/AJS3 as a new installation, you must set the binding method in the JP1/Base communication settings without using the procedure described below. If JP1/AJS3 is installed as an upgrade from 06-51 or earlier version of JP1/AJS2 in which the binding method applied to outgoing communication used in the execution of event jobs is already set, that setting is inherited. Note, however, that if JP1/AJS3 is re-installed, the inherited settings are lost. If you still want to use the same settings that were used in JP1/AJS2 06-51 or earlier, you will have to specify the settings manually.

The following describes the procedure for setting the binding method applied to the outgoing communication used in the execution of event jobs. Note that the procedure must be performed on the manager host and all agent hosts on which event jobs will be executed.

Organization of this subsection

(1) Definition procedure

  1. In Windows Control Panel, open the Services administrative tool, and stop the following service:

    • JP1/AJS3 service

  2. Execute the following command to set the environment setting parameter described in (2) below:

    jajs_config -k definition-key "parameter-name"=value
  3. Restart JP1/AJS3.

    The new settings are applied.

(2) Environment setting parameter

Table 6‒59: Environment setting parameter used to set the binding method for outgoing communication

Definition key

Environment setting parameter

Explanation

  • For all scheduler services

    [{JP1_DEFAULT|logical-host}\JP1AJS2\SCHEDULER\EV\MANAGER]#

  • For an event/action control agent

    [{JP1_DEFAULT|logical-host}\JP1AOMAGENT]#

"ClientBindFlag"=

Specifies the binding method applied to outgoing communication.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of these environment setting parameters, see 20.6.2(14) ClientBindFlag.