Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


6.2.23 Settings for re-executing the dependent units

This subsection describes how to configure the settings for re-executing dependent units. For details about how to re-execute dependent units, see 4.5.11(4) Re-executing the dependent unit of a judgment job in the manual JP1/Automatic Job Management System 3 Overview.

Organization of this subsection

(1) Definition procedure

  1. In Windows Control Panel, open the Services administrative tool, and stop the following service:

    • JP1/AJS3 service

    Cautionary note:

    In a cluster system, check the cluster settings, and also stop the JP1/AJS3 service on each logical host.

  2. Execute the following command to set the environment setting parameter described in (2) below:

    jajs_config -k definition-key "parameter-name"=value
  3. Restart JP1/AJS3.

    The new settings are applied to the configuration definition.

(2) Environment setting parameter

Table 6‒43: Environment setting parameter for re-executing dependent units

Definition key

Environment setting parameter

Explanation

[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]#

"RERUNSUBORDINATE"=

Specifies whether dependent units are to be re-executed.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of this environment setting parameter, see 20.4.2(106) RERUNSUBORDINATE.