Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


6.1.6 Enabling the suspend function

When you edit the definition of a subunit of a root jobnet during registration for execution, you need to enable the suspend function so that the root jobnet can be suspended.

Initially, the suspend function of JP1/AJS3 is disabled. Use the ajssetup command to enable it.

To enable the suspend function:

  1. Execute the following command to set up the environment for using the suspend function.

    ajssetup [-F scheduler-service-name] -m

    For details about the syntax of the ajssetup command and notes on the command, see ajssetup in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference.

You can enable the suspend function without stopping JP1/AJS3 services or scheduler services. (The setting takes effect immediately.) However, after you enable the suspend function, you will need to log in to JP1/AJS3 - View before you can perform operations in JP1/AJS3 - View.

For details about changing the definition of a subunit of a root jobnet during registration for execution, see 4.5.17 Changing job and jobnet definitions without unregistering the jobnet in the manual JP1/Automatic Job Management System 3 Overview.