Hitachi

JP1 Version 12 JP1/Automatic Job Management System 3 Configuration Guide


6.1.2 Changing the level of messages output from scheduler services to the integrated trace log

You can specify the level of messages output from scheduler services to the integrated trace log. The specification procedure is as follows.

Organization of this subsection

(1) Definition procedure

  1. In Windows Control Panel, open the Services administrative tool, and stop the following service:

    • JP1/AJS3 service

  2. Execute the following command to set the environment setting parameter described in (2) below:

    jajs_config -k definition-key "parameter-name"=value
  3. Restart JP1/AJS3.

    The new settings are applied to the configuration definition.

(2) Environment setting parameter

Table 6‒2: Environment setting parameter used to change the level of messages output from scheduler services to the integrated trace log

Definition key

Environment setting parameter

Explanation

[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]#

"HNTRLOGLEVEL"=

Specifies the level of messages to be output to the integrated trace log.

#:

The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of this environment setting parameter, see 20.4.2(56) HNTRLOGLEVEL.