8.8.1 Tasks required to upgrade JP1/AJS3 - Manager that uses the compatible ISAM configuration
This subsection describes the tasks required to upgrade JP1/AJS3 - Manager that uses the compatible ISAM configuration.
- Cautionary note
-
Before you start upgrading JP1/AJS3 - Manager, check the OSs supported by the desired version of JP1/AJS3 - Manager. If the OS of the host on which JP1/AJS3 - Manager is installed is not supported by the desired version of JP1/AJS3 - Manager, you cannot upgrade JP1/AJS3 - Manager on that host. If you cannot perform the upgrade directly on the host, prepare a manager host on which the desired version of JP1/AJS3 - Manager is installed, and then migrate the definition information from the JP1/AJS3 - Manager that uses the compatible ISAM configuration.
- Organization of this subsection
(1) Tasks required to upgrade JP1/AJS3 - Manager that uses the compatible ISAM configuration to JP1/AJS3 - Manager 11-10 or later
When you upgrade JP1/AJS3 - Manager that uses the compatible ISAM configuration to version 11-10 or later, you must perform the following procedure.
Note that the steps must be performed in the following order.
-
Change the database configuration from the compatible ISAM configuration to the standard configuration.
JP1/AJS3 - Manager 11-10 or later no longer supports the compatible ISAM configuration. Change the database configuration to the standard configuration before upgrading the version of JP1/AJS3 - Manager.
For details about how to change the database configuration, see 8.5.2 How to set up JP1/AJS3 - Manager after upgrading from JP1/AJS2 - Manager.
-
Install JP1/AJS3 - Manager as an upgrade installation.