8.7.1 Defaults of the environment setting parameters between versions 10-50 or earlier and versions 11-00 or later
In JP1/AJS3 version 11-00, some of the defaults of the environment setting parameters have been changed.
The following describes the differences between versions 10-50 or earlier and versions 11-00 or later.
- Versions 10-50 or earlier
-
Some of the defaults of the environment setting parameters are not their recommended values. You need to change the set values to recommended values as needed.
- Versions 11-00 or later
-
All the defaults of the environment setting parameters are set to their recommended values. Change the set values if you want to customize the values to better suit your environment.
However, even when JP1/AJS3 version 11-00 or later is installed, the defaults of the environment setting parameters might not be their recommended values depending on how the software was installed.
The following describes the defaults of the environment setting parameters for each method of installation:
- New installation:
-
If you install JP1/AJS3 version 11-00 or later in a new installation, the defaults of the environment setting parameters are set to their recommended values. Depending on your environment, consider whether you need to change the set value to the values used in versions 10-50 or earlier.
- Upgrade installation:
-
If you have JP1/AJS3 version 10-50 or earlier and install JP1/AJS3 version 11-00 or later as an upgrade installation, the default before the upgrade (the default of versions 10-50 or earlier) are set as they are. Therefore, some of the defaults of the environment setting parameters will not be their recommended values. Consider whether you need to change the set values to their recommended values. However, if you newly add a scheduler service, the defaults of the environment setting parameters for the scheduler service will be set to their recommended values. Therefore, the following environment setting parameters will have the defaults for versions 11-00 or later (recommended values) when a scheduler service is newly added, even in the case of an upgrade installation.
-
UNITDEFDIVIDEUPDATE
Set to yes to avoid failures due to exclusive resource shortages.
-
AJSPRINTSORTUNITINF
Set to yes to sort the output of the ajsprint command.
Consider whether you need to revert the set values to the values before the upgrade depending on your operations and environment.
-
For details about environment setting parameters whose defaults were changed to their recommended values in version 11-00, see C.2 Environment setting parameters whose defaults were changed to recommended values in version 11-00 in the JP1/Automatic Job Management System 3 Configuration Guide.