Hitachi

JP1 Version 12 JP1/Automatic Operation Messages


KNAE08154-E

Processing was interrupted because a file transfer failed (connection target: {0}, source path: {1}, destination path: {2}).

[Cause]

Possible causes are as follows:

(1) The destination host was rebooted during the connection.

(2) The source file does not exist.

(3) A write or read error occurred on the source or destination file.

(4) The name of the source or destination file exceeds 127 characters.

(5) When a folder was assigned for the source or destination, the absolute path of one or more files and folders exceeded 256 characters.

(6) When a folder was assigned for the source or destination, one or more paths after the assigned folder exceeded 127 characters.

(7) A network drive or a UNC path is specified as the path of the source or destination file or folder.

(8) A connection error occurred during the transfer.

(9) The destination host is overloaded.

(10) There is not enough free space on the system drive of the destination host.

(11) There is not enough free space on the drive on which the product is installed.

(12) A file to be transferred is encrypted.

[Action]

Check the following, and then execute the service again:

(1) The power status of the destination host

(2)-(7) The path of the source or destination file or folder

(8) The connection route to the destination host

(9) The load on the destination host

(10) The amount of free space on the system drive of the destination host

(11) The amount of free space on the drive on which the product is installed

(12) The attributes of the files to be transferred

If the problem persists, collect log information, and then contact your system administrator.

0: Host name or IP address of the destination host

1: Source path

2: Destination path