KNAE08139-E

A remote command could not be executed (connection target: {0}, maintenance information: {1}).

[Cause]

Possible causes are as follows:

(1) The destination host was rebooted during the connection.

(2) The destination host is overloaded.

(3) An error occurred with the connection to the destination host.

(4) There is not enough free memory on the destination host.

[Action]

Check the following, and then re-execute the service:

(1) The power status of the destination host

(2) The load condition of the destination host

(3) The connection route to the destination host

(4) The amount of free memory on the destination host

If the problem persists, collect log information, and then contact a system administrator.

0: Host name or IP address of the destination host

1: Maintenance information