Hitachi

JP1 Version 12 JP1/Automatic Operation Messages


KNAE08125-E

Processing was interrupted because command execution failed (connection target: {0}, command: {1}, current folder path: {2}, details: {3}).

[Cause]

Possible causes are as follows:

(1) The destination host is overloaded.

(2) The shell is in an invalid state.

[Action]

Check the following, and then re-execute the service:

(1) The load on the destination host

(2) Whether basic commands are executable by using the shell

If the problem persists, collect log information, and then contact a system administrator.

0: Host name or IP address of the destination host

1: Command

2: Current folder path

3: Details