Hitachi

JP1 Version 12 JP1/Automatic Operation Messages


KNAE04715-W

A connectivity check was performed for {0}, but there was no response.

A communication error may have occurred because {1} perform communications using {0} as the destination.

Verify the value.

Depending on network settings, this message may appear even if there is no problem with the specified value. If this is the case, ignore this message and continue the installation.

[Cause]

A communication error may have occurred because {1} perform communications using {0} as the destination.

[Action]

Verify the value. Depending on network settings, this message may appear even if there is no problem with the specified value. If this is the case, ignore this message and continue the installation.

0:host address

1:product name