KNAE04323-W

Installation was completed successfully, although JP1/Automatic Operation services or Hitachi Command Suite services failed to stop. The stop operation for services might have been delayed, or Tuning Manager might be linked to.

Wait a while, and then stop the services. If Tuning Manager is linked to, stop Hitachi Command Suite services at the remote destination, and then stop the services on the local server.

If you cannot stop the services, contact the Support Center.

[Cause]

JP1/Automatic Operation services or Hitachi Command Suite services failed to stop.

Possible causes are as follows:

- The management server was busy, and the stop operation for services was delayed.

- Hitachi Command Suite services on the management server were being used. This is because Tuning Manager on another server machine might be linked to.

[Action]

Try stopping the JP1/Automatic Operation services and Hitachi Command Suite services again. When Tuning Manager is linked to, stop Hitachi Command Suite services at the remote destination, and then retry the operation.

If you cannot stop the services, contact the Support Center.