4.7.1 Start event service of JP1/Base(UNIX)
Function
This component starts event service of JP1/Base on the execution target server in UNIX.
The server's prerequisites for this component are described below.
- Execution target server
Target server for executing this component
The script in this component executes the following command:
- jevstart ["value of the event server name (JP1Base.eventServerName property)"]
For details on the jevstart command of JP1/Base, see the description for the command in the JP1/Base manuals.
Use situation
Use this component when you restart event service of JP1/Base after modifying JP1/Base settings to make the modification take effect.
Note that this component finishes asynchronously without waiting until event service of JP1/Base starts completely, but you can use the "Obtain event service Status of JP1/Base" component after executing this component to wait until event service of JP1/Base starts.
Prerequisites
For the latest support information about [Required product in the System]/[Required products on the execution target server]/[Prerequisite product OS running in the execution target server], see the release notes.
[Required product in the System]
(1)JP1/Automatic Operation 11-00 or later
[Required products on the execution target server]
(1)Job Management Partner 1/Base 09-00 or later, or
JP1/Base 11-00 or later
[Prerequisite product OS running in the execution target server]
(1) Red Hat Enterprise Linux Server 6 (32-bit x86), Red Hat Enterprise Linux Server 6 (64-bit x86_64)
(2) Red Hat Enterprise Linux Server 7 (64-bit x86_64)
(3) Red Hat Enterprise Linux Server 8 (64-bit x86_64)
[Usage conditions for required products on the execution target server]
(1) Event service of JP1/Base is stopped.
Cautions
(1) For the properties of this plug-in, do not specify a string that includes a double quotation mark (") or single quotation mark (').
(2) For other notes on the command, see the JP1/Base manual.
Execution privilege
root permission
Version
02.02.00
Plug-in tags
Control JP1,Base,Linux
Plug-in name displayed in the task log
jp1baseEventStart
Return code
0: Normal
21: Error (invalid environment) Command cannot be found (error detected in the plug-in script)
27: Error (check task logs for the nature of error)
Property list
The following table lists the properties:
|
Property key |
Property name |
Description |
Default value |
I/O type |
Required |
|---|---|---|---|---|---|
|
plugin.destinationHost |
Host name of the execution target server |
Specify the host name or IP address of the server on which this plugin will be executed. IPv6 addresses are not supported. |
-- |
Input |
R |
|
JP1Base.eventServerName |
Event server name |
Specify the event server name. |
-- |
Input |
O |
|
common.returnValue |
Return value for the plugin |
The return value of this plugin stored. |
-- |
Output |
O |