3.7.2 Start the virtual server (repeated flow)
Flow specification details
The following table shows the detailed specification of the flow:
|
Hierarchy |
Processing |
Plug-in |
||
|---|---|---|---|---|
|
Plug-in name |
Description |
Error recovery method |
||
|
1 |
hypervGetVMState |
Obtain the virtual server status |
Obtains the virtual server status in the Hyper-V environment. |
After removing the cause of the error, run the service again. |
|
2 |
hypervPowerOnVM |
Starts a virtual server |
Starts a virtual server in the Hyper-V environment. |
-- |
|
2-3 |
Compatible Plug-in |
Determines if the virtual server is in a state other than "Start completed". |
After removing the cause of the error, run the service again. |
|
|
2-4 |
JP1/AO Custom Job |
If the virtual server is in a state other than "Start completed", starts the virtual server. |
After removing the cause of the error, run the service again. |
|
|
3 |
hypervCheckNetwork |
Check the network connection |
Checks whether the network is connected. |
-- |
|
3-3 |
Compatible Plug-in |
Determines if "yes" is specified for confirmation of the network connection. |
After removing the cause of the error, run the service again. |
|
|
3-4 |
Flow Plug-in |
If "yes" is specified for confirmation of the network connection, checks the network connection. |
-- |
|
|
3-4-1 |
JP1/AO Custom Job |
Obtains the IP address of the virtual server that has started. |
After removing the cause of the error, run the service again. |
|
|
3-4-2 |
JP1/AO Custom Job |
Issues an ICMP echo request to the virtual server that has started. |
Depending on the state of the system environment, the virtual server might successfully start but the network connection check might fail, possibly causing the task to end abnormally. Check if the virtual server has started. When executing the service again, check the notes and remove the cause of the error before doing so. |
|