8.3.20 Procedure for retrying a task from a failed step during debugging
If a debug task fails partway through, you can retry the task from the failed step.
By retrying from a failed step, you can resume the debug task with the same task ID and the original property values. You can use this approach when the cause of the failure has been resolved. For example, a step that fails due to a temporary problem with the network can be retried when the network connection is available again.
For details about retrying tasks, such as exceptions when property values are inherited and the possibility of retry depending on the status of a debug task, see Retrying tasks in the JP1/Automatic Operation Administration Guide.
To retry a task from a failed step during debugging:
Make sure that the debug task is in Failed status. Then, in the Debug area, from the Resubmit pull-down menu (
![[Figure]](GRAPHICS/F0000015.GIF)
), select Retry From Failed
Step.A dialog box appears in which you can confirm that you want to retry the task from the failed step.
Click OK.
Operation results
The task is re-executed from the failed step.