6.1.8 Setting a specific character set during plug-in execution

If you want the JP1/AO server to use a specific character set for communication when performing an operation on a UNIX device, enter the appropriate setting in a character-set mapping file, or in the terminal.charset key of a connection-destination property file.

If you specify a character set in a character-set mapping file and in the terminal.charset key of a connection-destination property file, the character set is assigned in the order of priority shown in the following table.

Table 6‒5: Priority of character set settings during plug-in execution
Priority	Setting
1	Character set specified in the terminal.charset key of the connection-destination property file
2	Character set specified in the character-set mapping file
3	Character set returned by the `locale charmap` command on the operation target device
4	UTF-8