5.4.2 Procedure for releasing a service template
When you select and release a service template, a package is created based on the service template and imported to the JP1/AO server. If the development environment is the same as the active environment, you are then able to create the service.
- Important
If a service template has been released, it cannot be re-edited. If you want to edit a released service template, copy it so that it can be edited.
If a service template contains a step that uses a service component, make sure that the release service template that the service component is based on has been imported to the JP1/AO server. If the release service template has been deleted or has not been imported, the release processing fails.
To release a service template:
-
On the Developing tab of the Service Builder Home window, select the service template you want to release, and then click the Edit button.
-
In the Service Builder Edit window, click the Release button.
Figure 5‒3: Service Builder Edit window ![[Figure]](GRAPHICS/F0000105.GIF)
In the confirmation window, click the OK button.
In the Build / Release Result dialog box, check the result, and then click the Close button.
Operation result
The service template is released. The release service template is displayed in the Service Templates window.
If the service template has been deleted or released by another user, an error occurs and the release processing fails.
If an error occurs during the release processing, a message is displayed to the operator that describes the cause of the error and instructs the operator to fix the flow. Then, at the upper right of the Service Builder Edit window, the Error button is displayed. After you close the message display, you can view the message again by clicking the Error button. This button is retained in the Service Builder Edit window until the operator closes this window.