3.6.3 Procedure for mapping step property values

To set mapping of step properties:

1. Select a step in the Flow area on the Flow tab of the Service Builder Edit window.

2. In the Step Properties area, click the Property tab and then click the icon for the input or output property.

3. Select the row corresponding to the property you want to map, and then click the pencil icon.

   Figure 3‒12: Step Properties area

4. In the Specify Component Input Property Mapping Parameters dialog box or Specify Component Output Property Mapping Parameters dialog box, select the View Property radio button.

   Only properties that can be mapped are shown in the Properties area.

   Figure 3‒13: Specify Component Input Property Mapping Parameters dialog box (when View Property is selected for Setting Method)

   Tip

   • If you click the Available icon (), filtering switches off and the properties that cannot be mapped are also displayed. If you point to an error icon, the reason why the property cannot be mapped is displayed.

   • Entering information into the Specify Component Input Property Mapping Parameters dialog box

     • To display service properties or variables

       Select a service template name in the Step Tree area. You can display the service properties that belong to a property group by clicking the icon to the left of the property group name. Variables are displayed in the default property group.

     • To display reserved properties

       In the Step Tree area, select a reserved property.

     • To display step properties

       In the Step Tree area, select a step name. The properties for the step are displayed in the Properties area. By default, the steps before the selected step are displayed in the Step Tree area. If you select the Show All Steps check box, all steps in the flow are displayed in the Step Tree area.

5. In the Properties area, select the property you want to map.

6. Click the OK button.

Operation result

Properties are mapped.

Tip

• You can create a new service property and map it to a step property. The service properties you created are displayed in the Specify Component Input Property Mapping Parameters dialog box or Specify Component Output Property Mapping Parameters dialog box, and can be mapped in the same way as step properties.

• If the visibility or data type is different between the mapping-source property and the mapping-destination property, an error might occur while the service template is built. For details about whether properties can be mapped depending on the visibility or data type, see 3.6.5 Whether properties can be mapped depending on the visibility or data type.

• By default, the Error message service property is provided for output properties. Error message is a service property used to output the Error Message to the Message area of the Task Details window. If you map Error message to the output property of a step, you can output the output property value as the Error Message in the Message area of the Task Details window.

  Note that you can edit or delete Error Message. If you delete Error Message and then add a service property with the same property key, the output property value is displayed in the Task Details window.