4.5.4 Procedure to change the port number between JP1/AO and the LDAP directory server
To change the port number between JP1/AO and the LDAP directory server, you must edit the definition file and register exceptions in the firewall.
In a cluster system, perform the same procedure on both the active server and the standby server.
Before you begin
Make sure that no user is logged in to the JP1/AO window.
To change the port number between JP1/AO and the LDAP directory server:
Change the port number by editing the following key of the definition file:
auth.ldap.server-identifier.port (see Note) in exauth.properties
- Notes:
-
For server-identifier, specify the same value specified for server-identifier for auth.server.name. The definition file is stored in the following folder:
common-component-installation-folder\conf or /opt/HiCommand/Base64/conf