3.5.3 Debugging and validating the service template
If the build finishes successfully, you must debug the service template and identify problems with the flow or plug-ins.
Before you begin
Permissions and roles required for this operation:
- A user who has the Admin or Develop role
Procedure
If all components included in the service template can be executed without any problems, first, execute a debug task without executing the service template in a step-by-step manner.
In this step, check whether there are problems with the processing transition in the flow and with the processing of each plug-in. If the service template contains any components that you do not want to execute, skip step 1, and start the procedure from step 2.
After determining all problems with the processing transition and plug-in processing, run a debug task, stopping processing for each step, to identify the locations and check the details of the problems.
You can also set a breakpoint at any step.
If necessary, change the values of input and output properties while validating the service template. You can run a debug any number of times by using the
Retry Debugpull-down menu in the
Service Builder Debugwindow.
Modify the service template in the Service Builder Edit window.
-
Build the service template again, and debug it. Repeat steps 1 to 4 until all problems are corrected.
-
Confirm that all problems have been corrected, and then terminate the debug.
Result
This triggers the debugging of the service template.