16.3 Provisioning information setting file (provisioning.properties)

This file specifies the provisioning information for JP1/ITDM2 - SDM (Smart Device Agent) that runs on a smart device.

Format

communicationserveraddress=connection-destination-communication-server-address
messagingseverurl=connection-destination-message-server-address
inventoryinterval=inventory-data-collection-interval
gpsinterval=GPS-information-collection-interval
lowbattery=battery-capacity-to-send-inventory-data-at-low-voltage

Setting items

The following describes the setting items and specifiable values for the provisioning information setting file:

Setting item	Description	Specifiable value	Initial value
communicationserveraddress	Specify the address of the connection destination communication server. This item must be specified.	`host-name:port-number` `host-name` Host name of the communication server (FQDN format) `port-number`^#1 The communication server HTTPS port number for SSL communication (default: 26055)	None
messagingseverurl	Specify the address of the connection destination messaging server (for Android only). This item must be specified.	`host-name:port-number` `host-name` Host name of the messaging server (FQDN format) `port-number`^#2 The messaging server HTTP port number for communication (default: 26079)	None
inventoryinterval	Specify the inventory data collection interval.	0 to 24 (in hours)^#3	24
gpsinterval	Specify the GPS information collection interval.	1 to 24 (in hours)	24
lowbattery	Specify the battery level for sending inventory data in the event of low voltage. You can specify multiple values separated by commas. Example: `15,10,5`	1 to 100 (%)	5

#1

This port number must be the same as the port number specified in the httpsd.conf file for the communication server.

#2

This port number must be the same as the port number to be set for HttpPort in the messaging server setting file (SdMessagingServer.ini).

#3

If 0 is specified, inventory data will not be collected.

If the number of managed devices reaches or exceeds 1,000, the collection of inventory data might take more than an hour. For this reason, set 2 or a greater value.

Example

communicationserveraddress=xxxxxxx.xxxxxxx.co.jp:26055
messagingseverurl=xxxxxxx.xxxxxxx.co.jp:26079
inventoryinterval=24
gpsinterval=24
lowbattery=10,5

Related Topics

16.7 Messaging server setting file (SdMessagingServer.ini)

To Page Top