7.3.5 Setting Mail Notification Information
Mail Notification Information specifies whether you wish to have Task Scheduler use email to report on asset status. If so, you can specify the report recipient's email address. For details about setting the tasks registered in Task Scheduler, see 7.9 Setting the tasks that are registered in Task Scheduler.
Also specifies whether to send an email notification to a user who is set up as an Item agent when an Item is executed. For details about setting up an Item agent, see 15.2.2 Specifying a substitute.
This section describes the settings for Mail Notification Information.
- Organization of this subsection
(1) Notification by e-mail
Notification by e-mail specifies whether you wish to have Task Scheduler automatically send an email notification.
To send an email notification, specify Notify.
-
Permitted value
-
Notify
Sends an email notification.
-
Do not notify (default)
Does not send an email notification.
-
(2) Email notification to Item agents
When an Item agent is set up, Email notification to Item agents specifies whether to send an email notification to the Item agent.
To send an email notification, specify Email. In this case, the user who is set up as the Item agent receives a copy of the notification (CC).
-
Permitted value
-
Email
Sends email notifications also to the Item agent.
-
Do not email (default)
Does not send email notifications to the Item agent.
-
(3) Address to e-mail
Address to e-mail specifies the destination address when you wish to send email notification of the execution results of a task registered in the Task Scheduler. To specify multiple destination addresses, use commas (,) as the delimiter.
If you wish email notification to be sent, make sure that you specify this item.
-
Permitted value
String of 5-160 alphanumeric characters, the underscore (_), hyphen (-), and
period (.), delimited by the at mark (@). The default is a space.
(4) Sender's e-mail address
Sender's e-mail address specifies the sender's address when you wish to send email notification of the execution results of a task registered in the Task Scheduler. To specify multiple sender's addresses, use commas (,) as the delimiter.
-
Permitted value
String of 5-160 alphanumeric characters, the underscore (_), hyphen (-), and
period (.), delimited by the at mark (@). The default is manager@asset.message.