13.19.8 JOB_CLIENT_CONTROL (specifying client control)
In the JOB_CLIENT_CONTROL tag, specify how to control the client. This tag is used only for the dcminst command. Even if this tag is specified for other commands, this tag is ignored.
The following table shows the parameters that can be specified, and their corresponding command arguments:
Parameter |
Content |
Command argument |
---|---|---|
Whether to start the client |
/WWU |
|
Whether to shut down the client |
/WUS |
- Organization of this subsection
(1) Format
JOB_CLIENT_CONTROL { client_wake_up=whether-to-start-the-client client_shutdown=whether-to-shut-down-the-client }
(2) Description
-
client_wake_up=whether-to-start-the-client
Write Y or N to specify whether to start the client.
- Y
-
Starts the client.
- N
-
Does not start the client.
When no value is specified in this parameter, N is set automatically.
-
client_shutdown=whether-to-shut-down-the-client
Write Y or N to specify whether to shut down the client.
- Y
-
Shuts down the client.
- N
-
Does not shut down the client.
When no value is specified in this parameter, N is set automatically. Note that this parameter is invalid for agents for UNIX.