2.8.1 Overview of building a JP1/NETM/NM - Manager linkage configuration system
To build a system that links with JP1/NETM/NM - Manager, you first need to build a minimal configuration system. You can then deploy network control appliances. Next, install JP1/NETM/NM - Manager, and enable linkage with JP1/NETM/NM - Manager.
-
Build a minimal configuration system.
-
Deploy and set up a network control appliance in each monitored network segment.
-
Install JP1/NETM/NM - Manager on the management server.
-
Set up JP1/NETM/NM - Manager.
To run JP1/IT Desktop Management 2 in a cluster system, also run JP1/NETM/NM - Manager in a cluster system by installing JP1/NETM/NM - Manager on the same secondary server.
-
Register network segments and groups to be monitored in JP1/NETM/NM - Manager.
-
Specify the environment settings of network control appliances in JP1/NETM/NM - Manager.
-
Set quarantine communication information (settings for quarantine-exempt connections) on the network control appliances.
-
In the Settings module of JP1/IT Desktop Management 2, click Network Access Control to display the Assign Network Access Control Settings view. Then, for the network segments to be monitored that were registered in JP1/NETM/NM - Manager, change the settings so that notification is not sent when the segments are not monitored.
If you use the blacklist method to manage network connections, skip step 9. Perform step 9 only if you use the whitelist method to manage network connections.
-
Edit the network control settings file (jdn_networkcontrol.conf) stored on the management server. For details about this procedure, see 4.6.6 Procedure for editing the network control settings file.
-
In JP1/IT Desktop Management 2, enable linkage with JP1/NETM/NM - Manager.
For details about this procedure, see 4.6.5 Enabling the JP1/NETM/NM - Manager linkage settings.
Building of the JP1/NETM/NM - Manager linkage configuration system is complete.
Related Topics: