1.7.8 Deploying agents to selected groups of computers on which agents have not yet been installed
You can deploy agents to selected groups of computers to be managed.
- Tip
-
During agent deployment, approximately 80 MB of data is sent to each computer.
To deploy agents to selected groups of computers:
-
In the Settings module, select Agent and then Windows Agent Deployment to display the Windows Agent Deployment view.
If the agents to be deployed include a remote control agent, go to step 2. If the agents to be deployed do not include a remote control agent, go to step 5.
-
In Settings of the Components of the Agents to Be Deployed, click Edit.
-
In the displayed dialog box, select the Include remote control agents check box.
-
Click OK to close the dialog box.
-
Select the computers to which you want to deploy agents.
-
Click the Deploy Agent button.
-
In the displayed dialog box, select an agent configuration you want to apply to computers.
-
Click the OK button.
Agents are deployed to selected computers. To view the agent deployment status, in the Settings module, select Agent and then Windows Agent Deployment to display the Windows Agent Deployment view.
- Tip
-
An agent is installed to the folder specified in the default agent configuration. If you have changed the installation folder, you need to specify the drive and the write-enabled folder. Note that the specified agent configuration is applied to computers after the installation is complete.