4.4.13 JP1/NETM/NM - Manager linkage configuration
By linking with JP1/NETM/NM - Manager, JP1/IT Desktop Management 2 can control network connections monitored on network control appliances.
- Important
-
You cannot place a network control appliance in a network segment with the network monitor enabled.
The following figure shows a JP1/NETM/NM - Manager linkage configuration.
In a multi-server configuration, perform either of the following to link with JP1/NETM/NM - Manager:
-
Install JP1/NETM/NM - Manager on management servers that monitor network connections through network control appliances.
-
Install JP1/NETM/NM - Manager only on the primary management server.
In this case, you must configure the primary management server to enable automatic update of the network control list for the devices that are managed by management relay servers under the primary management server.
Note that JP1/NETM/NM - Manager cannot manage JP1/NETM/NM via a NAT device. If you want to use JP1/NETM/NM - Manager to manage network connections in a NAT environment, you must install JP1/NETM/NM - Manager on a management relay server placed in the NAT environment.
Related Topics: