3.2.4 Installation procedure using the Hitachi Program Product Installer
This subsection describes the following operations that you perform by using the Hitachi Program Product Installer:
-
Starting the Hitachi Program Product Installer
-
Using the Hitachi Program Product Installer to install JP1/DH - AJE
-
Using the Hitachi Program Product Installer to uninstall JP1/DH - AJE
-
Using the Hitachi Program Product Installer to check the versions of currently installed Hitachi products
- Organization of this subsection
(1) Starting the Hitachi Program Product Installer
-
Set the JP1/DH - AJE distribution media.
-
Mount the distribution media. For details about how to mount the distribution media, see the documentation for the OS.
/bin/mount -r -o mode=0544 /dev/cdrom /mnt/cdrom
- Note:
-
-
The name of the device special file (/dev/cdrom) and the name of the mount-point directory for the file system of the distribution media (/mnt/cdrom) differ depending on the environment.
-
-
Start the Hitachi Program Product Installer.
The directory and file names of the distribution media might be seen differently depending on the environment. Enter a file name in the same form as displayed by the ls command.
/mnt/cdrom/X64LIN/setup /mnt/cdrom
- Note:
-
-
For /mnt/cdrom, specify the mount-point directory for the distribution media.
-
-
Unmount the distribution media.
After installation is complete, unmount the distribution media. For details about how to unmount the distribution media, see the documentation for the OS.
/bin/umount /mnt/cdrom
- Note:
-
-
For /mnt/cdrom, specify the mount-point directory for the distribution media.
-
(2) Using the Hitachi Program Product Installer to install JP1/DH - AJE
-
In the initial screen of the Hitachi Program Product Installer, enter I.
A list of program products that can be installed is displayed.
-
Position the cursor at the product that you want to install, and then press the space bar to select that product.
-
Enter I.
Installation of JP1/DH - AJE starts. After installation is complete, you can redisplay the initial screen by entering Q.
(3) Using the Hitachi Program Product Installer to uninstall JP1/DH - AJE
-
Start the Hitachi Program Product Installer by executing the following command:
/etc/hitachi_setup
-
In the initial screen that is displayed, enter D.
A list of program products that can be uninstalled is displayed.
-
Position the cursor at the product that you want to uninstall, and then press the space bar to select the product.
-
Enter D.
The selected program product is uninstalled. You can redisplay the initial screen by entering Q.
(4) Using the Hitachi Program Product Installer to check the versions of currently installed Hitachi products
-
Start the Hitachi Program Product Installer by executing the following command:
/etc/hitachi_setup
-
In the initial screen that is displayed, enter L.
A list of currently installed Hitachi program products is displayed.