C.13 Registering services to cluster software
Register the JP1/DH - Server services to your clustering software.
- Organization of this subsection
(1) In WSFC:
Register the following services by using the Failover Cluster Manager. All the services must be created as a Generic Service Resource.
-
JP1_DH_DATABASE_SVR
For details about the settings, see Table C-8 Database service settings.
-
JP1_DH_WEB_CONTAINER
For details about the settings, see Table C-9 Service settings for the JP1/DH Web application server.
-
JP1_DH_WEB SVR
For details about the settings, see Table C-10 Service settings for the JP1/DH Web server.
(2) In HA Monitor:
Specify the following paths to files used by HA Monitor in the server configuration file servers.
Each file can be found in the /opt/jp1dh/server/sbin/cluster directory.
-
Server program (which is the startup command)
Set the name directive in the servers file to /opt/jp1dh/server/sbin/cluster/JP1_DH_CLUSTER_START.
-
Command to shut down the server
Set the termcommand directive in the servers file to /opt/jp1dh/server/sbin/cluster/JP1_DH_CLUSTER_STOP.
-
Monitoring command
Set the patrolcommand directive in the servers file to /opt/jp1dh/server/sbin/cluster/JP1_DH_CLUSTER_PATROL.
In the cluster configuration, HA Monitor starts and stops the services. Thus, the automatic service startup mechanism, which is used in the non-cluster configuration, must be turned off by executing the following commands:
>/JP1/DH-Server-installation-folder/sbin/chkconfig JP1_DH_DATABASE_SVR off >/JP1/DH-Server-installation-folder/sbin/chkconfig JP1_DH_WEBCON off