KNAX6100-E
Execution of the command "command-name" failed. exit status=exit-status-code [file name="file-name" line=line-number]
Execution of a command failed. When this message is displayed, the return code displayed in the KNAX7999-I message is ignored and return-code displayed in this message is set as the job's return code.
- command-name
Name of the command that failed to execute
- exit-status-code
Job's return code
- file-name
Name of the job definition script file
- line-number
Line number in the job definition script file where the error occurred
- (S)
Terminates processing.
- (O)
Eliminate the cause of the error based on the KNAX6098-E message output immediately before this message, and then re-execute the job definition script. If the problem is still unresolved after re-execution, contact the system administrator.