3.4.4 Notes on changing IP addresses
If you change the IP address of a host in a system where JP1/AJS3 - Print Option is linked with JP1/AJS3 - View, take the following measures in addition to those required by JP1/Base, JP1/AJS3, and JP1/AJS3 - View:
-
Before changing the IP address, stop the following JP1/AJS3 - Print Option Manager service:
JP1/AJS3 POM service
-
Make sure that the service has stopped, and then change the IP address.
-
If you are changing from an IPv4 address to an IPv6 address, open the jprpoml.ini file and add the following definition:
[common] IPv6connect = 1
For details on the location of the jprpoml.ini file, see D.2 Product file information for JP1/AJS3 - Print Option Manager.
Notes:
-
If you are using a non-Administrator account in a Windows Server 2016, Windows Server 2012 or Windows Server 2008 R2 environment with User Account Control (UAC) enabled, promote the account to administrator status before editing the jprpoml.ini file.
-
Only Windows Server 2016, Windows 10, Windows 8.1, Windows Server 2012, Windows 8, Windows 7, Windows Server 2008 R2, and Linux support the use of IPv6 addresses.
-
The default setting for IPv6connect in the jprpoml.ini file is as follows:
In Windows Server 2016, Windows Server 2012, Windows Server 2008 R2, and Linux:
IPv6connect = 1
In AIX, Solaris, and HP-UX(IPF):
IPv6connect = 0
-
-
Restart the service you stopped in step 1.
-
If you changed from an IPv4 address to an IPv6 address, add the -6 option to the startup command in JP1/AJS3 - View.
For details on setting the startup command in JP1/AJS3 - View, see 3.4.2 JP1/AJS3 - View setup.
If you are not linking JP1/AJS3 - Print Option with JP1/AJS3 - View, you do not need to do any of the above when you change the IP address.