1.4.2 Enabling administrative shares
To use service templates that use the general command plug-in, file transmission plug-in, or content plug-in at a connection destination that runs on Windows, you must enable administrative shares.
- Caution
-
JP1/AO does not support the system configuration in which multiple JP1/AO servers connect to a single connection destination that runs on Windows.
Procedure
-
To enable administrative shares, configure registry settings as shown in the following table, and then restart the OS on the connection destination.
Table 1‒8: Registry settings (administrative share settings) Item
Value
Registry key
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Lanmanserver\parameters
Registry entry
AutoShareServer
Value to be set in the registry entry
1 (DWORD)
- Tip
-
You can also use the following command to specify administrative share settings:
reg add HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Lanmanserver\parameters /v AutoShareServer /t REG_DWORD /d 1