1.3.1 New installation of JP1/AO (in Windows)

Use the Hitachi Integrated Installer to install JP1/AO.

Before you begin

You must finish necessary tasks before installing JP1/AO, such as checking the server on which JP1/AO will be installed and installing prerequisite products.

Procedure

Insert the distribution media, and then execute the Hitachi Integrated Installer.
Follow the wizard to configure settings.

Specify the JP1/AO installation folder.
The information that was specified in the wizard is displayed. Check the content.
If necessary, click the Advanced Settings button to change the following items:
- Installation folders for the databases
- IP address or host name of the JP1/AO server
- Port number of the JP1/AO server
- Whether to back up databases, and the backup folder
  
  As the preparation for an installation failure, specify whether to back up the databases that are shared with Hitachi Command Suite products and set the backup folder. You must set these items only when Hitachi Command Suite products have been already installed.
Click the Install button to start the installation of JP1/AO.
When JP1/AO is installed, the installation wizard for JP1/AO - Contents appears.
Specify the installation folder for JP1/AO - Contents.
The information that was specified in the wizard is displayed. Check the content.
Click the Install button to start the installation of JP1/AO - Contents.
In Windows, if you enter a value other than the default port number, perform the procedure to change a port number.
After the installation is complete, execute the hcmds64srv command with the start option specified to start the JP1/AO services.
Location where the commands are stored:

Common-Component-installation-folder\bin

Example of executing the command:

hcmds64srv /start

Result

The installation of JP1/AO starts.

The following product names are displayed in Programs and Features under Programs in the Control Panel in Windows.

Table 1‒6: Product names that are displayed in *Programs and Features*
Product name	Version
Job Management Partner 1/Automatic Operation	`vv`.`rr`.`mm`
Job Management Partner 1/Automatic Operation - Contents	`vv`.`rr`.`mm`

JP1_Automatic Operation is added to All Programs in the Start menu.
Some ports used for external connections in JP1/AO are registered as firewall exceptions.

Caution

If you interrupt the installation, an empty folder might be created. If an empty folder is created, manually delete it.
If the installation of Common Component fails and you attempt to install it again, you cannot specify an installation destination different from the previous installation destination. Even if you enter a different installation destination, Common Component is automatically installed in the previous installation destination.